top of page
3D Printed Recovery System
-
Wanted a reliable recovery system that did not use pyro charges
-
Servo locks fairing and parachute in place, tensioning rubber band
-
Opening servo releases fairing and parachute
-
Ejection power can be tuned by varying the number of rubber bands
-
Simple solution that worked more effectively than previous versions
-
Designed in Fusion360
Solenoid Ejection (V1)
-
Used solenoid to eject fairing and parachute
-
Fairing splits in half after ejection, allowing parachute to fall out
-
Required perfect fit to eject reliably without falling off
-
Standard solenoids are not powerful enough for their weight
-
Fairing too small for parachute
Servo Opening (V2)
-
Much larger fairing, opened by servo
-
Required spring to eject parachute
-
Difficult to design spring that was synchronized with fairing opening
-
Ultimately too complex
bottom of page